Board connection fault (main – motor – panel). The main PCB, motor PCB and panel PCB are not connected properly.
Shown on Brother machines including 311H, 311HN, 341H, 342G, 430D, 430F, 430FX, 430HX, 438F, 6200A, 7000DD, 7100A and others.
Switch the machine off before touching any connector. If the code comes back after these checks, the fault is usually in the control boxes, PCBs and sensors.
Request a repair for this error or WhatsApp the code and your model to +91-9643480908 (Monday to Saturday, 10:00 AM to 8:00 PM (closed Sunday)).
Summarised by Shankar Sewing from the BAS 311H SERVICE MANUAL (page 138); HE 800B SERVICE MANUAL (page 139); BAS 311H instruction manual (page 81); BAS 311HN BAS 326H instruction manual (page 64); BAS 341H BAS 342H instruction manual (page 63). The manual has the complete procedure and connector numbers for your exact model.
E010 Stop switch pressed in standby · E015 Stop switch held at power-on · E016 Stop switch connection fault · E050 Head tilted when the treadle was pressed · E051 Head tilted while sewing · E055 Machine head switch position · E065 Panel key stuck · E111 Needle-up stop position not reached · E130 Motor stopped / synchroniser fault · E131 Motor encoder signal fault · E132 Blown fuse on the motor PCB · E133 Motor PCB or upper-shaft motor fault · all Brother codes
Board connection fault (main – motor – panel). The main PCB, motor PCB and panel PCB are not connected properly.
Check that the green LED LD3 is lit on the main PCB and on the motor PCB, then check the connectors between the boards. If the code stays, the fault is usually in the control boxes, PCBs and sensors.
In the manuals we have read, E410 appears on 311H, 311HN, 341H, 342G, 430D, 430F, 430FX, 430HX, 438F, 6200A and other models.